Home Home Home Home Home Home Home Home
Round nose solid carbide upcut spiral bits
Round nose solid carbide upcut spiral bits
Round nose solid carbide upcut spiral bits
Round nose solid carbide upcut spiral bits
Round nose solid carbide upcut spiral bits
Round nose solid carbide upcut spiral bits

WARNING : Drilling, sawing, sanding or machining wood products can expose you to wood dust, a substance known to the State of California to cause cancer; Avoid inhaling wood dust or use a dust mask or other safeguards for personal protection. For more information go to www.P65Warnings.ca.gov/wood.

[0, ] California Proposition 65

Round nose solid carbide upcut spiral bits

199

Sharp technology with a new twist

A special super-micrograin carbide formulation was created to produce and hold a keen cutting edge. The new low-angle spiral is designed specifically to shear wood cleanly and provide efficient chip ejection. The tools run cooler and the edges last longer.

Increased feed rate and improved cutting quality for enhanced productivity with CMT!

TECHNICAL FEATURES:
Premium quality HWM.
2 spiral cutting edges (Z2).
Provide an excellent finish on the lower side of the workpiece.
Upward chip ejection.

Details
used for efficient contour cutting, end-trimming and panel sizing on solid wood, wood composites, plastic materials and laminates at high feed speed. Ensure to properly clamp workpieces. Can be used on machining centres, point-to-point boring machines, CNC routers and hand-held routers equipped with chucks or adaptors. Cost-effective solution with respect to brazed and spiral in tungsten carbide.
Variations
Filter
Item Code D R I L S MAT RH-LH
199.001.11
199.001.11 1/8'' 1/16'' 1/2'' 2'' 1/4'' HWM RH
199.008.11
199.008.11 1/4'' 1/8'' 1'' 2-1/2'' 1/4'' HWM RH
199.504.11
199.504.11 3/8'' 3/16'' 1-1/8'' 3'' 3/8'' HWM RH
199.505.11
199.505.11 1/2'' 1/4'' 1-1/4'' 3'' 1/2'' HWM RH
199.509.11
199.509.11 5/8'' 5/16'' 2-1/4'' 4-5/16'' 5/8'' HWM RH
199.511.11
199.511.11 3/4'' 3/8'' 2-1/4'' 4-5/16'' 3/4'' HWM RH